• Linatex anti-abrasive premium red rubber is the standard sleeve lining.
• Clamp-on end connection facilitates valve’s installation into existing piped systems.
• Sleeve ends slip over standard wall pipe.
• Full bore/full flow design results in low friction loss and high flow capacity.
• Center pinch design for predictable linear flow performance, reduced turbulence and longer sleeve wear life.
• Extended sleeve length improves sleeve closing and opening performance, reduces stresses on sleeve clamp-on end connections and minimizes wear on adjacent piping.
• One piece sleeve protects operating mechanism and body parts from exposure to process.
• High flexibility sleeve design reduces closing forces, improves recovery to full open position and ensures drip tight shut off.
• Open body configuration allows easy visual evaluation of valve position, simplifies valve maintenance and sleeve replacement and lowers weight.
• Elastomer sleeve reduces piping vibration and water hammer.
• Low force manual handwheel actuation

Options:

• Wide variety of natural rubber and synthetic rubber sleeve linings.
• Special sleeve designs include reduced bore, extra heavy linings and ultra flexibility.
• Pneumatic, electric and hydraulic actuators with a full range of control systems.
• Custom body and sleeve designs for special service applications

Construction:

• Heavy-duty cast and fabricated steel bridge, pinch anvils, side plates and end supports. Assembled with high quality fasteners and premium screw-stock steel
  tie rods.
• One piece vulcanized pinch sleeve is reinforced with multiple layers of high tensile strength fabric cord.
• Premium quality abrasion and/or corrosion resistant rubber lining on sleeve’s interior surface; ozone, oil and UV resistant outer cover.
• Double acting pinch mechanism with single input shaft.
• Cast iron handwheel features standard full circumference style on 11/2 inch through 3 inch sizes and exterior spoke assisted style on 4 inch through 6 inch sizes.